Mud-club

Vehicle & Technical => Discovery => Topic started by: muddywatt on July 28, 2007, 20:37:07

Title: central locking on a TD5
Post by: muddywatt on July 28, 2007, 20:37:07
AAAARRRRGGGGGHHHHHHH

OK we are on holiday and the disco has locked herself and we can't unlock her with the remote. we have checked the fuse and it seems ok any ideas of how to get her to unlock with out the remote.

It will work with the key

I think it must be a loose connection as it worked after a short drive then it stopped working later on after another short trip

the fuse looks OK and I cant see anything loose but where is the sensor for the remote central locking as it is the only thing i think could be affecting it

Also had the roof lining half off to cure a leek from the sun roof and had the interior light disconnected

if anybody is around the gainsbrough area we can meet for some help
Title: central locking on a TD5
Post by: pitcaig on July 28, 2007, 21:28:29
Hi
I also get this sometimes with my TD5, but I just open it using the EKA method and then the remote seems to work ok again.
Try moving the car as sometimes interference from other radio signals stops it from working.
Hope this helps

Cheers
Graeme
Title: central locking on a TD5
Post by: muddywatt on July 30, 2007, 12:22:10
Ok we have an answer of sorts the Disco seems to be allergic to my friends drive way we go about 10m in either direction and the remote central locking starts to work

it must be his French car
Title: central locking on a TD5
Post by: foxkilla on July 30, 2007, 19:43:07
it is probably electromagnetic interference, are you parked near overhead power lines or next to a substation?
Title: central locking on a TD5
Post by: muddywatt on July 30, 2007, 19:49:52
Nope on both but my mate lives in a new housing estate that is still being built
Title: central locking on a TD5
Post by: Hightower on July 30, 2007, 20:22:58
Just a thought, but have you checked the micro-switches inside the key fob?  Mine started playing up and it was those that were the problem.  They needed carefully resoldering to the PCB.  Haven't had an issue since . . .
SimplePortal 2.3.5 © 2008-2012, SimplePortal