Mud-club

Vehicle & Technical => Range Rover => Topic started by: R2D2 on April 23, 2010, 09:41:25

Title: MOT failed on steering
Post by: R2D2 on April 23, 2010, 09:41:25
Hi folks, rrc 3.5 efi lpg 1986.

Freeplay at steering wheel is what it says, so wondered if there is any adjustment to take up/tighten the steering?

Oh, forgot to say it has pas,.... also failed on n/s track rod end so will be replacing that and tightening the tie bar end on n/s.

Eagerly await any advice thanks.
Title: Re: MOT failed on steering
Post by: Bobtail on April 23, 2010, 14:12:58
It is probably the ball joint that it failed on

Giving excessive movement

It probably meant you could turn the wheel before the wheels start moving

hope this helps

Jim
Title: Re: MOT failed on steering
Post by: JIMBOBLY on April 23, 2010, 20:59:33
if it is the drop arm ball joint thats got the play in it,they should point it out properly,but i'd say its the steering box that needs adjusting,which you can do by undoing the big nut on top of the steering box,then turn the adjuster in the middle of the nut,then retighten the nut when you have got all the play out,but be careful not to go to far or the steering will either have a tight spot,or just go tight full stop,because of wear on the main shaft in one place,straight ahead possition usually,hope this helps mate.
Title: Re: MOT failed on steering
Post by: doda456 on April 23, 2010, 22:12:48
It could also be the steering ujs,

There easy to change, and examine, just get an assistant to wiggle the steering wheel and check for play.
Title: Re: MOT failed on steering
Post by: JIMBOBLY on April 24, 2010, 17:25:44
It could also be the steering ujs,

There easy to change, and examine, just get an assistant to wiggle the steering wheel and check for play.
yeah,funny you should say that,i'd forgot that i'd replace that shaft on mine about 3 months ago, :lol:
SimplePortal 2.3.5 © 2008-2012, SimplePortal