Mud-club
Vehicle & Technical => Discovery => Topic started by: Iain Williams on September 02, 2007, 16:11:00
-
Has any one got some pic's of the Rear Shock Absorber Top Mount Dropper Kit? Can’t see how the bolts that come on the back plates fit to the chassis. (Too short) thanks
-
hahah you did the same as i did at first! :lol: hang on
-
right heres how it works. what ya need to remember is that its a drop plate, not a shock mount - you still use the original mount. the short studs that are welded on are what the mount bolts to... the long allen bolt thats with it goes through the chassis, and then you need two extra "through the chassis bolts" to finish off.
when i bought ours, i didnt actually realise i'd bought a drop plate rather than a -2" mount. took me a few minutes to work out what the hell was going on, so you're not alone ;)
-
thanks for the pic, make it lot more sens now
-
no worries mate