Mud-club
Vehicle & Technical => Series Land Rovers => Topic started by: Batfink82 on November 08, 2006, 13:34:57
-
Hi, I have some new interia reel seat belts i want to fit to my series 3. Has anyone else done this? where is the best place to mount the reel?
all thoughts are welcome!
-
on the door jam thingy bit down by the seat box....
-
yeah thats where i was intending to put them but they are too big. i have come up with another solution........
The landy used to be a truck cab, its now going to be a rag top. So to fit the top point of the seatbelt im going to remove the box section part inside the truck cab and bolt it on to the edge of the tub. i will then weld a couple of braces between the two sections. The lower part of the seatbelt can then be bolted at the side of the seat box.
-
There should be a mounting hole for the seatbelt to mount onto the second bulkhead. The standard non-inertia type has the piece that goes over the shoulder mount on the secondary bulkhead, and this is where I have mounted the inertia seatbelt reel on my 2A.