Mud-club

Vehicle & Technical => Nissan => Topic started by: Brian the Sn@il on April 19, 2006, 06:11:02

Title: Navara Front A Bar too low ? heres the fix
Post by: Brian the Sn@il on April 19, 2006, 06:11:02

I bought a front a bar for the Navara D40, and the front fixings were way to low. Bent them on a green lane.

So what i did was cut down the front lower fixings by 50mm. Thus raising up the A Bar 50mm

You need a Hacksaw and a migwelder to carry this out and took me about 1 hour to do.

I also did this without taking the complete A bar off, i did one side at a time.

50mm isnt much, but its better than it was. At a real push 60mm can be achieved, but im not re doing it just for 10mm :lol:

Title: Navara Front A Bar too low ? heres the fix
Post by: Brian the Sn@il on May 13, 2006, 20:19:04

ypu can now see the top of the A bar from the drivers seat, which makes you feel good :lol: and it gets more respect ;)

Title: Navara Front A Bar too low ? heres the fix
Post by: Brian the Sn@il on July 05, 2006, 19:25:03

with muddy pics

(http://scoobycity.co.uk/phpBB2/files/5_287.jpg)
(http://scoobycity.co.uk/phpBB2/files/4_150.jpg)
(http://scoobycity.co.uk/phpBB2/files/3_152.jpg)
(http://scoobycity.co.uk/phpBB2/files/2_158.jpg)
(http://scoobycity.co.uk/phpBB2/files/1_112.jpg)

Title: Navara Front A Bar too low ? heres the fix
Post by: Firestarter on July 05, 2006, 20:15:55

great, thanks for the pics Brian  :D

Title: Navara Front A Bar too low ? heres the fix
Post by: Firestarter on July 05, 2006, 20:59:02

........................ the 2 L-shaped bars that go into the front grille, are they bolted to the fixing by the top of the rad with 2 x 10mm nuts (not supplied)?

Title: Navara Front A Bar too low ? heres the fix
Post by: Brian the Sn@il on July 06, 2006, 22:09:52

yep the 2 stainless bits of flat bar, bolt to the rad fixings using the 10mm bolts.

I think you undo the existing ones and screw them back on.