Mud-club
Vehicle & Technical => Series Land Rovers => Topic started by: Robbo on June 19, 2006, 12:26:12
-
Hi
Anyone know where the switch is? and where I can get another from as Paddocks don't seem to have one - hmmm - strange! :?
-
should be on the pedal inside the footwell
-
Hi
Anyone know where the switch is? and where I can get another from as Paddocks don't seem to have one - hmmm - strange! :?
On a series 2 its on the union under the drivers floor area, on a series 3 check on brake servo area (engine bay side)
;)
-
SIII one is on a bracket just infront of the pedal arm.
your toes point at it when you are braking :lol: :wink:
-
SIII one is on a bracket just infront of the pedal arm.
your toes point at it when you are braking :lol: :wink:
Cheers
Can you adjust it? as my lights seem to have a non-consistent working routine! or is it just to replace it instead? robbo
-
Can be twisted clockwise or anti-clockwise until it works properly :wink:
-
which bit do i twist? it all looks sort of untwistable? :?
-
It should look similar to the one below but it will have two nuts on it, you loosen the outer nut then move the inner one up or down the threaded bit then lock the outer one back up
-
...thats looking similar to mine, I'll have a twist and see what happens!