Mud-club
Vehicle & Technical => Range Rover => Topic started by: R2D2 on April 30, 2008, 13:54:53
-
Hi Guys.
Would like to change my Dizzy/coil/amp setup on the 3.5 rrc efi. mainly 'cos I keep drowning the amp on mine which is both expensive and located on the wing under the coil.
Have picked up, from a 3.5 efi 'H' reg (mine is a D reg) a dizzy (with the smaller bolt on amp) plus the coil with all leads as well. This car was running when it arrived at the breaker's yard.
So my question is: Is it a straight swap and is the wiring an issue? 8-[ 8-[
I know I will have to make sure the dizzy goes in on the exact same position as mine comes out or it may never run again :shock:
All advice welcomed.
-
the wiring to the coil may be different as at the moment and guessing you only have 1 wire from the coil to the dizzy? could be wrong. but no biggy thou wack it in wire her up not rocket science and then she'll need timining up after.