Mud-club

Vehicle & Technical => Defender => Topic started by: burgerman on June 10, 2008, 16:38:30

Title: Saggy or not
Post by: burgerman on June 10, 2008, 16:38:30

  Following on from a previous thread ----- Wifeys 90, A 2001 TD5 CSW, appears to have saggy springs :( , But before i order up a new set (with dampers) can i compare my measurements please ??   From the centre of the wheel/hub to the bottom edge of the Wheel arch trim is 19 inches front and the same on the  back ,


   So before my itchy finger is hovering over the BUY button :lol: could some please pop out n measure theres please ??



 Many thanks

Title: Re: Saggy or not
Post by: Jimbo on June 10, 2008, 18:35:18

110 Td5 hardtop (ok, not quite the same vehicle :oops:)

21" rear
20.5" front

And that's on 265/75/16 MT's

Title: Re: Saggy or not
Post by: Saffy on June 10, 2008, 18:47:31

does the workshop manual not state the proper ride height measurements? sure I seen a diagram somewhere.

Title: Re: Saggy or not
Post by: burgerman on June 11, 2008, 13:08:14

Quote from: Saffy on June 10, 2008, 18:47:31

does the workshop manual not state the proper ride height measurements? sure I seen a diagram somewhere.

  Dunno  :-k  Havent even got a haynes manual for it  :roll:

Thought it had overall vehicle heights on the inside if the sunvisors somewhere ? but not that i can find anymore :doh:


Might pop up the main stealers this afternoon and sneak around with a tape measure  :lol: