Mud-club

Vehicle & Technical => Defender => Topic started by: AbyssDJ on January 30, 2007, 18:26:26

Title: UJ's
Post by: AbyssDJ on January 30, 2007, 18:26:26

are 110 front prop UJ's slightly smaller than the back ones?

Title: UJ's
Post by: Dave on January 30, 2007, 19:10:44

No i don't think so, but there are different sizes for different yoks you may have the two different props your best bet is alldrive nip in let tony have a look and get the right size for the one you have.

Title: UJ's
Post by: AbyssDJ on January 30, 2007, 19:40:27

cheers, i didnt think they were different either..... picked up 4 off matty today. will check them tomorrow

Title: UJ's
Post by: mud-club-matty on January 30, 2007, 20:31:49

they are different part numbers for the front and back trust me

Title: UJ's
Post by: AbyssDJ on January 30, 2007, 20:32:40

Quote from: "mud-club-matty"

trust me

will the world end if i do? ;)

Title: UJ's
Post by: mud-club-matty on January 30, 2007, 20:32:40

Quote from: "Dave"

No i don't think so, but there are different sizes for different yoks you may have the two different props your best bet is alldrive nip in let tony have a look and get the right size for the one you have.

whats wrong with midland 4x4!

Title: UJ's
Post by: mmgemini on January 31, 2007, 10:40:48

There are different size yokes to different props.
Depending as to the flavour of the supplier of the day.

Title: UJ's
Post by: Xtremeteam on January 31, 2007, 19:35:37

Quote from: "abyssdj"

Quote from: "mud-club-matty"

trust me

will the world end if i do? ;)

dunno if we would want to do that :lol:

Title: UJ's
Post by: mud-club-matty on January 31, 2007, 21:10:02

be nice liam iv even ordered you on specialy in

Title: UJ's
Post by: extreme90 on January 31, 2007, 21:14:46

just to confuse matters on mine, front is large bearing cups, rear is small, and i still get them mixed up  :oops:
dan

Title: UJ's
Post by: Devon-Rover on January 31, 2007, 21:28:33

Whats the VIN say as they do differ over time.

Title: UJ's
Post by: dreadnought110 on January 31, 2007, 21:29:18

Quote from: "thebiggreenthing"

just to confuse matters on mine, front is large bearing cups, rear is small, and i still get them mixed up  :oops:
dan

one advatage of a 110 you have to be pretty stupied to get them mixed up :wink:  :wink:                               I'll get me coat :oops:  :oops:

Title: UJ's
Post by: AbyssDJ on January 31, 2007, 21:31:48

james (jjsaul) checked it against some wierd and wonderful pdf last night, and our chassis number apparently corresponds to GKN U110's, which is what i have in thr front of the landrover and they look about right, so we will see

Title: UJ's
Post by: extreme90 on January 31, 2007, 21:35:58

you'll soon no when the 1st bearing cup comes out
if it different youll soon tell
 :wink:
dan