Mud-club

Vehicle & Technical => Jeep => Topic started by: wizard on May 23, 2005, 07:55:16

Title: Axle breathers info required
Post by: wizard on May 23, 2005, 07:55:16

As you may or may not know, i make sets of axle and gearbox breather kits for Land Rovers, now i want to make some kits up for the Jeepers out there.
What i need to know is the thread size on the original axle (and gearbox if fitted) breathers.
I will offer a FREE kit in return for this info, and will require a few piccies for our web site when the kit has been installed.

So if you have a Cherokee or Wrangler and fancy a set of breathers.......


Regards
wizard :twisted:

Title: Axle breathers info required
Post by: wizard on June 03, 2005, 06:32:28

Blimey, does nobody want free stuff ???????????? :shock:


wizard :twisted:

Title: Axle breathers info required
Post by: EvilEd on June 03, 2005, 10:23:41

Hi, only just seen this.... I'll see if I can find out for you.

Will also try to find out if all the different axles have the same fitting.

If I remember right (I looked into this a while back and still havn't fitted my safari) the Transfer case breather is the problem as it is attached to the top of the case itself rather than a tube. I know there's a write up about it somewhere so I'll try to find that too. (Scratch that, found it here http://www.darksiderz.co.uk/technical/breather/index.htm)

Let me know exactly what you need, but be aware that there are loads of different setups depending on what year and what model you have.
CJ - Civilian Jeep
DJ - Dispatch Jeep
MJ - Comanche
SJ - Wagoneer
YJ - 1987-95 Wrangler
TJ - 1997 and current Wrangler
XJ - Cherokee
ZJ - Grand Cherokee (up to 1998)
WJ - Grand Cherokee (1999 on)
KJ - New Cherokee/Liberty

You'll probably get more info if you post this on somewhere like J33p.org (Free)

Title: Re: Axle breathers info required
Post by: barmiebrumie on June 03, 2005, 10:53:39

Quote from: "wizard"

As you may or may not know, i make sets of axle and gearbox breather kits for Land Rovers, now i want to make some kits up for the Jeepers out there.
What i need to know is the thread size on the original axle (and gearbox if fitted) breathers.
I will offer a FREE kit in return for this info, and will require a few piccies for our web site when the kit has been installed.

So if you have a Cherokee or Wrangler and fancy a set of breathers.......


Regards
wizard :twisted:

hi, could you let me know how much for a set of breathers for a 1976 range???

thanks john.

Title: Axle breathers info required
Post by: wizard on June 04, 2005, 08:31:08

Thanks for the info Eviled, I will have a good look at it later.

Cheers
wizard :twisted:

Title: axle breathers
Post by: barmiebrumie on June 04, 2005, 09:37:49

8) hi wizard, just need to get some of swmbo's bingo money & i'll be haveing me some of them, :wink:  :wink:

thanks john.