Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: brixworth-alan on September 19, 2010, 09:17:27

Title: wheel studs question
Post by: brixworth-alan on September 19, 2010, 09:17:27

OK, so I ordered some replacement wheel studs from Paddocks and what do u know they're the wrong sort, as I need the screw in type not the push in type (doh). Before I go and order them from LR series though, is there just one type or did they vary as well? LR series part says 'series 1, 2 and very early 2as'- mine is a '66 plater so not very early.

Can anyone advise? cheers Alan

Title: Re: wheel studs question
Post by: bogie on September 20, 2010, 20:20:20

Hi mate,the early studs were 9/16 and the s3 were 16mm.The early 9/16 were screw in and the later were push in from the back.All the bearing carriers are interchangable if that helps.

Title: Re: wheel studs question
Post by: brixworth-alan on September 21, 2010, 22:06:28

Cheers- looks like I got early carriers on a later car then :)

Hey- ever find that axle case?

Thanks!

Alan

Title: Re: wheel studs question
Post by: bobtailed disco on September 29, 2010, 10:27:11

i replaced mine with the push in ones (were thredded) just drilled the hub out