Mud-club
Vehicle & Technical => Jeep => Topic started by: Bofh on June 26, 2009, 19:53:20
-
Hi everyone, I have a knackered BCM on my N reg grand cherokee acording to my Jeep mechanic. I've heard that I can replace the unit as long as it's matched with the serial numbers on the back of the unit.
Can anyone confirm this please, I want to shift the Jeep as it's been sat on the drive for the last 8 weeks doing nothing so I thought I'd sell her on as I think its still worth a few bob as it's LPG converted.
Any advice chaps?
-
Body control module?
Can't see it interacting with the ecu apart from for the full closure, so as long as the moduel comes from the same spec / age ZG then you should be OK.
-
Many thanks mate, don't suppose you have any tips on how to remove the old one, I got seriously fedup trying to remove it and now I'm trying to sell it without fixing it I'm so sick of it sitting on the drive.
-
? It's located behind the kick panel drivers side isn't it? Doesn't it just unplug and bolt off?
-
That's correct, although actually getting the damn thing off nearly drove me mental last week. I managed to remove about 8 wire clips but was too stressed to manage the few clips right down the end by the bulk head. It's not an easy job trust me, althoug I think I'll have another go this weekend, finger crossed.
Cheers
-
Believe it is plug and replace so a s/h unit will do...try trawling the US GC sites such as NAGCA for advice