Mud-club
Vehicle & Technical => Range Rover => Topic started by: Pete5844 as was on August 03, 2006, 21:15:08
-
Ok folks I've sent off for the book of knowledge but it's not here yet so can anyone tell me is there a torque setting for the track rod ends and if so what is it.Cheers Pete
-
According to my bible
4 06 1
Steering
ball joint nuts.............................. 40 Nm or 30 lbf ft
For some reason they don't refere to them as TREs but they are the same thing. the value is aproximate as you will probably need to tighten them up/un do them a fraction so that the hole in the TRE lines up with the castalations on the nut, assuming the TREs you have use a split pin to stop them turning.