Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: Artwigwa on October 29, 2006, 14:06:45

Title: Chassis Bump Stops Dont Fit?
Post by: Artwigwa on October 29, 2006, 14:06:45

Hi all, Help?! On my SWB series petrol the rear bump stops dont fit! it's as if the chassis rails are to wide? and yet the front fit fine...? Whats going on? :-k

Title: Chassis Bump Stops Dont Fit?
Post by: Rich_P on October 29, 2006, 18:27:46

Looks like the bump stop isn't wide enough.  Has it had a new rear quarter chassis at some point?

Title: Chassis Bump Stops Dont Fit?
Post by: Artwigwa on October 29, 2006, 18:45:18

Hi, new rear quarter chassis... not sure but even so surely the stops would fit wouldnt they?

Looking at this picture (attachment) the rails look much narrower than mine :?:

Title: Chassis Bump Stops Dont Fit?
Post by: Rich_P on October 29, 2006, 19:18:25

If the rear quarter is anything like the new rear crossmember with extensions, is that it is designed to slide over the ends of the remaining section of chassis.  So as a result, the replacement sections of the rails will be wider.