Mud-club

Vehicle & Technical => Defender => Topic started by: bodgeitjo on March 10, 2012, 18:17:37

Title: no brakes
Post by: bodgeitjo on March 10, 2012, 18:17:37

i finally got round to putting the new pistons in the calliper(wasnt to hard) and put on new extended hoses.bleed them loads theres no air bubbles at all, yet the pedal goes to the floor. any ideas cheers jo.

Title: Re: no brakes
Post by: lambert on March 11, 2012, 08:14:13

I trust you bled all 4 rear near side first then ros then fns and then front off side. All the unions are tight and dry and all the pipes are in good order? Is there any resistance in the stroke of the pedal or does it just drop under your finger pressure?