Mud-club

Vehicle & Technical => Not Anything Listed Above.... => Topic started by: Barry Scott on August 21, 2005, 16:45:01

Title: Frontera reverse light problems
Post by: Barry Scott on August 21, 2005, 16:45:01: OK, so when I got my Frontera, the reverse lights were controlled by a switch hanging off the dash, obviously the old loght failed so the previous owner bodged it.

Now I have purchased a new reverse light switch(after testing the old one with a multimeter and finding it always gives out the on signal) and after a lot of messing about, fitted it.

Guess what, reverse lights are alway on!!!!! :evil:

Whatever gear it is in the reverse light stays on, any ideas?
Title: Frontera reverse light problems
Post by: Sharpshooter on August 21, 2005, 18:03:35: It is common on alot of cars, that when the reverse switch is old, it will stick. It is a small plunger type switch, wwhich when you select reverse, pushes the plunger in and make a contact. When the switch gets all the old gammy oil round it it will stick on, giving you your Always On Prob. Change the switch (Approx Ã‚Â£10) Had the same prob on my vectra, or take the switch out and clean it up. It might work. :D
Title: Frontera reverse light problems
Post by: Barry Scott on August 21, 2005, 18:06:48: Changed the switch, no joy :(

I left the word "switch" out of my first post.
Title: Frontera reverse light problems
Post by: Sharpshooter on August 21, 2005, 18:20:06: Then you may need to pack out the switch with washers. They dont necessarally screw all the way home. Try putting it in gear, and screwing it in until the light comes on the take it out of gear and see if they go out.

Also have you tried it with the switch connected but not in the box??

The othe thing to check, is have you got a feed down both of the wires that go to the switch??
Title: Frontera reverse light problems
Post by: Barry Scott on August 21, 2005, 18:28:39: Just tried it out of the box, without pressing the ball of the switch in, the lights are on. when I push it in the lights go off :?
Title: Frontera reverse light problems
Post by: Sharpshooter on August 21, 2005, 18:31:05: I would say that you need to adjust it then with a washer. Either that ofr you have the wrong switch.
Title: Frontera reverse light problems
Post by: Jim-Willy on August 21, 2005, 20:54:27: Reverse lights aren't compusary. Not part of the MOT. Why bother, mines never worked?
Title: Frontera reverse light problems
Post by: Barry Scott on August 21, 2005, 21:26:04: Quote from: "jim-willy"
Reverse lights aren't compusary. Not part of the MOT. Why bother, mines never worked?

Stuff like this bugs me, but I am starting to think like that after today.
Title: Frontera reverse light problems
Post by: Sharpshooter on August 21, 2005, 21:58:55: That attitude is ok, until you back into your best mates Rangs Rover in the dark, and damage yours and his motor... :oops: