Mud-club

Vehicle & Technical => Range Rover => Topic started by: RR Paul on October 19, 2004, 19:42:53

Title: bloody cold in here
Post by: RR Paul on October 19, 2004, 19:42:53

The pipes to the heater matrix have been bypassed, making me think that the matrix is knackered.
someone told me to "re connect it and chuck a load of radweld in it"
someone else told me " what ever ya do, do NOT use radweld!!!"
I'm confused now!
I can get a new matrix for £70, I think i'll go this route! apparently there are two sizes. Is there anyway of finding out the size without removing the complete dash??
F.Y.I I have a 93 LSE 4.2 (as it says below!)  :roll:

Title: bloody cold in here
Post by: MUSKIE on October 19, 2004, 20:46:27

from past experience the heater matrix is an absolute pig to change. yours might go easier though.

Title: bloody cold in here
Post by: Merlin on October 19, 2004, 21:02:47

Theres a good chance you can find one on "E" bay for a lot less than £70, loads of new stuff for Classics on there, dont know where it comes from--Cogs

Title: bloody cold in here
Post by: RR Paul on October 19, 2004, 21:15:49

I need to find out the size before i get one though  :(