Mud-club

Vehicle & Technical => Series Land Rovers => Topic started by: baron von ledwidge on October 10, 2010, 22:06:59

Title: series 3 clutch slave nut size and pitch
Post by: baron von ledwidge on October 10, 2010, 22:06:59

I whipped the clutch slave out of my project series 3 a while back and have lost the nuts, does anyone know what size and pitch these are so i can order some more?
thanks
aaron

Title: Re: series 3 clutch slave nut size and pitch
Post by: Series 3 Brad on October 25, 2010, 14:51:38

not sure whether it would make much difference if it was a petrol or diesel, ive got an old series 3 petrol im breaking and just happen to have them haha, havent got them off it yet though so not sure of the condition of them......not had much time to poke around with it recently.
If they are in good condition i will whip them out for you, if you havent already got some.

Brad

Title: Re: series 3 clutch slave nut size and pitch
Post by: baron von ledwidge on October 25, 2010, 20:34:15

hey buddy im ok thanks i whipped one out of my other landy and went down the local nuts and bolts supplier and got 2 new screws for it so all is good, but thanks for the offer