Mud-club
Vehicle & Technical => Defender => Topic started by: crusader on January 15, 2008, 22:48:20
-
I have A bit of a Dilemma on my Hands?
I would like to Lift the Truck by Obviously 2 ins?
However i have here 2 Brand New Scorpion Range Rover Standard H/D Rear Springs Plus 50%
Which i was thinking on Fitting to the Front to Sort out the Weight of my Winch and Winch Bumper... Which in Theory should give me a Nearly 2ins extra on the Front?
Am i Correct?
But now i am Confused on what to Stick in the Back?
Should i Fit Just Normal Back + 2 inch Springs?
To make it Clearer? As Fog? to me that is?
-
the best thing to do it to ring colin at scorpion and ask him what's spring rate on the springs you have
then we can advise here
as really its a guessing game
ideally you want +2 springs with a 200 or 210 lbft spring rate then a 220lbft on the rear
dan
-
I had a disco which i put a 2" lift on and i put the rear springs on the front by mistake,they just dont fit,if i were you id put the scorpion springs on the rear and get uprated + 2" spring s for the front,I swear by bearmach springs but its up to you :D
-
Sounds like i need to put these in the for sale section of the club and start again? :oops:
-
i would say your springs are around 320LBft as a rough guess going by normal spring rates
this would be way way way to hard for the 90, it would give it a 4 inch lift :P
dan
-
i would say your springs are around 320LBft as a rough guess going by normal spring rates
this would be way way way to hard for the 90, it would give it a 4 inch lift :P
dan
OoooooH Thats way too much for a little fella like Little ole Me? :lol: :lol: :lol: