Mud-club
Vehicle & Technical => Defender => Topic started by: Mutz on August 27, 2007, 16:23:31
-
Got the old ones out no problem (they are very worn).
How on earth do you put the new ones back in??????
So far put loads of lubricant on them and tried guiding them in using vice, but stops just before it needs to pop through the taper bit in the middle.
HELP!!!!!!!!!!!!!
again :cry:
-
If the are the ones with the metal sleve in the centre, cut them in half. They cant go anywhere once they are in.
-
squese them in the vice but space the oposite side you are pushing the bush from back from the vice abit to give it some room to pop in,lots o grease on the bushes & it will pop in no problem
-
Did the vice bit again, plenty of grease, spaced it, and used a washer on the bush to even the pressure and low and behold poped in a treat.
Thanks all for your replies.
Graham