Mud-club
Vehicle & Technical => Defender => Topic started by: markthespark on July 07, 2007, 17:38:32
-
does anybody have any idea where the wash wipe relay is on a 90
my wipers won't stop and i think its the washer relay that has jammed in the run on cycle after washer has stopped water
i know we have had a lot of rain but i would like to turn my wipers off now as it has stopped for the mo.
cheers
-
I'm sure I'll be corrected but isnt it behind the metal bit that the fuse box cover screws to?
-
Check its not a fault at the stalk/switch end too.
-
I'm sure I'll be corrected but isnt it behind the metal bit that the fuse box cover screws to?
it is and its red, or at least it is on mine
-
does anybody have any idea where the wash wipe relay is on a 90
my wipers won't stop and i think its the washer relay that has jammed in the run on cycle after washer has stopped water
i know we have had a lot of rain but i would like to turn my wipers off now as it has stopped for the mo.
cheers
Had this on mine. Changed everything until i realised it was the relay :roll:
It is in the fuse box you can't miss it it is the largest rectangular thing in there. IIRC about £20+ to replace. Try drying it out gently and replace it, then give it a good coat of silicone around the joint. Mine was due to water ingress through the join where the cap meets the body, causing it to short
HTH
-
cheers will check it out this weekend but i did manage to stop the wipers by disconnecting the yellow wire offov the wiper motor although fast speed does not work now it means i can drive without the wipers wiping