Mud-club

Vehicle & Technical => Discovery => Topic started by: burgerman on August 05, 2008, 23:18:04

Title: fitting a stepper motor
Post by: burgerman on August 05, 2008, 23:18:04

 Any tricks to fitting a "new" stepper motor to a 1991 V8 3.5 disco ? ?      Is it just a case of unplugging/unbolting old one and replacing? OR do i need to set up/reset/adjust the new item ??   Any tips welcomed :lol:

Title: Re: fitting a stepper motor
Post by: Range Rover Blues on August 06, 2008, 03:15:02

I always juts stick them in.  The ECU should callibrate the stepper every time the engine starts.