Mud-club
Vehicle & Technical => Discovery => Topic started by: feenix on October 08, 2007, 23:56:35
-
has, er... fallen off :evil: Is this common on Discos? The mount looks paper thin along one side (rust?), the other has just fatigued through. Axle is pretty rusty, is there a chance of welding on a new mount if they are available? If not I guess I'll need another casing and spend some time swapping the bits over or just chance a breakers axle. :(
-
Not 100% sure but try Paddocks 08454 584499 (UK local rate)
They are normally good. If not it will be a call to an inderpendant specialist.
I use Rockingham Land Rovers 01536 770078
I hope this helps
Rich
-
Check the state of all the other axle brackets as they are likely to suffer the same fate with more severe consequences.
-
If one mount has rusted through then I would check the whole of the axle casing carefully, the spring mounts will probably be rotten too.