Mud-club

Vehicle & Technical => Range Rover => Topic started by: The Mercian on August 13, 2003, 09:30:31

Title: Heater unit..Classic
Post by: The Mercian on August 13, 2003, 09:30:31

how di do. :D .Has anyone tried to work on / removed etc a Rangie heater unit,got probs with mine,red hot in summer ,cold in winter just wondered what they were like to get at / out. :roll:

Title: Heater unit..Classic
Post by: muddyweb on August 13, 2003, 11:44:21

Depends on the year I think as the dashes were different.

Last one I took out was when I dismantled a vehicle....  so that was easy 8-)

Title: Heater unit..Classic
Post by: George the Disco on August 13, 2003, 12:14:36

Having spoken to a bloke in a pub....

Disconnect the two pipes at the back of the heater unit and push them into the engine bay, then the heater unit should be quite easy to get into the passenger footwell without removing the complete dashboard.

Have fun  :twisted:

Chris

Title: Heater unit..Classic
Post by: The Mercian on August 15, 2003, 22:03:44

sounds to easy.. :D .but i`ll give it a go,cheers :roll:

Title: Classic Heaters
Post by: BAZZ on September 16, 2003, 23:38:07

:shock:
Hi Mercian, if it's a late classic then the Dash has to be stripped, there's no other way. Also when you have the heater out, check the matrix is o/k. These can give problems, if you need to purchase a replacement then take some measurements, the size doe's matter. there are several different sizes so do take time to check, don't just order or you may end up with wrong size replacement unit. My rangie is a 93 tdi and has a disco heater unit !! so do check. BAZZ.  :oops: