Vehicle & Technical > Defender

Advice for Newbie

<< < (2/2)

Soldmybikeforthis:
Thanks for the response. The Drop arm tightening was done by a garage, twice, and I know the washer bends down on the nut, but I'll have to check they have it going up onto the box as well.

The chassis legs going to right up to the springs sounds good to me, as the chassis is a bit rotten quite far along.

kevinf:
i recently had a problem keeping drop arm ball kits in my steering arm
 found the replacement arm about £40.00 from paddocks.so not worth
missing about with repair kits if in any doubt,also could rectify your recurent loose drop arm problem




good luck kevin

Xtremeteam:
in response to replacing the arm completly it gets expensive after the firsat 1 as the repair kits are £12 + vat,the size o the socket is 1" 5/16 but dont quote me on that as was doin a pas box 2 day

V8MoneyPit:

--- Quote from: "V8_redline7500" ---...... the size o the socket is 1" 5/16 but dont quote me on that as was doin a pas box 2 day
--- End quote ---


If that's the case it'll be useful, I sell those at work for Mini front hub nuts! But in 1/2" drive. I'll try one.

Navigation

[0] Message Index

[*] Previous page