Vehicle & Technical > Range Rover

A frame thingy

<< < (3/3)

Mad Max 3:
Hi, I am no expert, :oops:  but I us an angle grinder and cut through the thing, just leaving the ball bit in place. I have done this several times and it has not caused me or the vehicle any problems

Range Rover Blues:
That's the way to do it, LR special tool #2 through all the bolt heads and use it to dismantle the lower end ball joint.  Alternatively the lower ball joint screws out of the self leveling unit piston rod, then you should be able to strip it down and bin the parts you don't need.

Mental note, must do this myself sometime.

rokcrawlin:
beware when cutting this unit it is under pressure and can spit oil at you or catch fire wear protective clothing and have an extinguisher handy

barmiebrumie:
:lol: hi,
 think all the oil & pressure must have gone, had to grind off the top four bolts & got the cutting gear out for the bottom part, made sure everthing was soaked in water & had fire extinuisher at the ready, thanks everybody for all the good advise, will post a pic'y of it sitting high & proud when i can get it loaded on,


john.

Navigation

[0] Message Index

[*] Previous page