Vehicle & Technical > Discovery
Urgent Diagnosis help needed
Xtremeteam:
for everything 19mm upwards i have a 2 foot long 1/2inch ratchet & for everything under that i have a 3/8's long ratchet & for diffs n shafts,stuff like that,use the air gun on No2 which is TIGHT (bout 100+nm) :lol:
gords:
--- Quote from: "Paul" ---
--- Quote from: "gords" ---does anyone know what torque the nuts should be tightened to? (diff to axle)
--- End quote ---
36 - 46 Nm
or
26 - 34 ft.lbs
--- End quote ---
Bloomin heck - what a guess :shock: I did 42 Nm :)
Range Rover Blues:
--- Quote from: "karloss" ---
--- Quote from: "ChrisW70" --- especially if its been done by an overzealous workshop monkey with an air line
--- End quote ---
Bit of a myth anyway that one, you can get much more torque with a normal ratchet than you ever will with an impact wrench. (below 3/4 inch drive)
--- End quote ---
Do you think so :?
Xtremeteam:
i have to kinda agree with karloss
Range Rover Blues:
My experience has always been the opposite, without a 3/4 inch socket set at least.
Cavalier hub-nuts spring to mind.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version