Vehicle & Technical > Series Land Rovers

landy 109 series 3 starter thingy

<< < (3/6) > >>

generation-x:
hi m8
i doubt its mud to be honest as its never been off road its an ex recovery truck

simon

iianorthants:
don't have to be mud, has had a few year of abuse :) any leaking oil from back seal and a bit of clutch dust can make a sticky mess (quick check of breather hole on bottom of bell housing to see if any oil could indicating a leak) .
the starter motors on the petrol's are so basic very rarely they go wrong.
 best thing to do is take it out spin it over to see what happens. easy job and once off will be easy to see if any damage.

generation-x:
hi ian
if i cross the soleniod the starter spins but wont engage the fly wheel so as you say it may be sticking but nowt happens when turnin the key no noise no spinning which makes me think theres some thing wrong with the soleniod as well as i said there is a wire by it that is yellow comin from the loom shud this be attached to the soleniod?

simon

hobbit:
It could be the switching wire from the ignition, is there a broken spade end on the solenoid? or has the wire got a spade inside it?

hobbit:
just looked on mine, if its a white wire with a red stripe its the ignition feed fire, and should fit on a spade on the solenoid

kev

Navigation

[0] Message Index

[#] Next page

[*] Previous page