Vehicle & Technical > Series Land Rovers
It lives !
Saffy:
Battery now mounted into the seat box. New cables made up from battery to starter motor solenoid and earth strap to chassis. Made a start on some of the loom mods. The starter turns over with key so that's sorted.
Have refitted the original series solenoid to the the bulkhead and have routed the glow plug cabling through it.
such slow progress :rolleyes:
Welshbreed:
--- Quote from: Saffy on May 05, 2012, 22:48:29 ---such slow progress :rolleyes:
--- End quote ---
As is life my friend, as is life
Saffy:
End is in sight - kinda.
to do...
bolt up wings to front panel.
install Front panel loom.
Wire up some sort of leccy fan control.
Fit the oil cooler (no idea how I'm going to connect it up yet)
Fit exhaust reducer (temp solution)
figure out what I am going to do in regards to the temp/oil sensors
figure out what I am going to do with air intake/ air filter.
block off the heater pipes (no heater in my truck)
add coolant - engine oil - fuel and fire it up and write a list of snags :D
Hightower:
Good on you Saffy.
I know exactly how you feel. Still to do on mine:
Bolt on wings, fit mud guards underneath
Fit doors
Glaze door tops
Wire up lights front and rear
Rejig seat mounts
Looking for some good weather to finish....
lambert:
So near to done, well done both of you.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version