Vehicle & Technical > Discovery
disco prop
gee the sparky:
with a 2" suspension lift i wouldnt need to do anything to the prop or coupler would i??
the rubber ring prop coupler has chewed itself up in a matter of 2 months, and it doesnt look as if the prop is 'in line' with the shaft that comes out of the diff?
James.Harwood:
Probably worth swapping for a prop without the rubber donut. The extra angle will chew it to pieces.
Skibum346:
Building on James H's answer...
You'll need to remove the three hole drive flange from the nose of the rear diff and fit a 4 hole one from a 200tdi. Then you can fit a 4 hole prop...!
Just a note... the nut holding the drive flange on will need a b****rd bar with an aformentiond b****rd hanging off the end... to release it!
Skibum
gee the sparky:
ahhh...sounds like i didnt do my homework before i raised it then, but my previous lifted disco was a 200 so that explains why ive not had a problem in the past.
cheers for the quick replies dudes, is it a straight forward swap??
James.Harwood:
Believe so, not done one though.
Navigation
[0] Message Index
[#] Next page
Go to full version