Vehicle & Technical > Series Land Rovers

Front Axle probs?

(1/2) > >>

kevinragman:
Good afternoon. Just another quickie? no pun intended!! On me series, i have a clicking when reversing and now have a lot of play in the ns wheel, what i mean by this, i removed the cap over the hub nut, the hub ut is tight, really tight and split pin in place,. but theres play in it, i can pull the nut and thread, back and forwards not much but its moving. slight oil there but not dripping out. plus when on my standard wheels, it clonked when turning, whilst moving. got quite worried so swapped me wheels and tyres for me disco wheels with muds on ready for the snow, nothing? got me steering damper on too as when i had my 31x10.5x15s on it had really bad wobbles, over a pot hole or drain, uncontrolable! but on the flat, fine!! new axle me thinks!! any ideas??

Saffy:
cv joint is probably shot.

edit (i meant uj!)

Lucy1978:
if it's a series axle it could be the UJ (they don't have CV's)
No need to replace teh axle just because one part of it is worn out.

kevinragman:
Hi, thanks guys! don't u think the diff has a part too, as i can grab the prop, and turn it half a turn before it does anything! back one is much different, much tighter! If its just the hub, ill replace that but for the swivel and bearing including shims is near 100 quid, then if the diff is up the spout, ill have to get that too!! mmmm confused!!

tack43:
Broken half shaft? Or diff?

Navigation

[0] Message Index

[#] Next page