Vehicle & Technical > Discovery

200 tdi prop to 300 tdi dicso

(1/2) > >>

300TDi Disco:
HI guys, just about to start changing the flange on the rear diff, it is true that i will need a spacer for the new prop? It has been lifted 2".


cheers

Matt.

90Mike:
No mate no spacer needed. What you up to tomorrow  :wink:

Jake:
if you fitting a 4 bolt flange instead of the 3 bolt then yes, you will need a spacer ring.

 :cool:

90Mike:
 :huh: Even if the flange on the diff has been changed for a 4 bolt type from a 200tdi ?

ChrisW70:
Depends on the flange you are fitting, there's a 49mm high and a 61mm high flange - you need a 539745 pinion washer if you're fitting the shorter flange, goes over the pinion before you fit the flange.

If I remember, I think you have the longer flange Matt but a tape measure to check the overall height will sort it.

Navigation

[0] Message Index

[#] Next page