Vehicle & Technical > Series Land Rovers
300tdi Auto into a 2a?
L90OOK:
Hi all, I am thinking of putting a Disco 300tdi with Autobox into my 2a. The original gearbox is knackered & engine is thirsty 2.25 petrol :rolleyes:
Has anyone done this?
I'm guessing the rear prop is going to be short but as it's going to be used on road it's not an issue for me.
Any pointers would be helpful!
Many thanks :afro:
Lee_D:
Not with a 300tdi but have done it with a 4.2 XK engine and auto box mated to an ashcroft adapter for the mounting of the transferbox. :cool:
Both props are likely to be requiring a swap as its unlikely either will be same lenth as they currently are.
You need to mount the Rad, Intercoolder and I'm assuming the autobox cooler so the front of the IIa will be needing some adjustment. I just fitted a 90 grill and bonnet on my conversion.
more details on my web site on the links to Project Percy. Click the banner below. :afro:
Lucy1978:
can be done, tdi conversion is quite easy, 200 even sits on teh original mounts an dbolts up to a series gearbox. 300 needs engine mounts moving. autobox has been done, but not by me, Jim Willy has had a couple of series autos so may be able to give pointers.
NiteMare:
the 300tdi will sit on the original chassis mounts with a little creative thought and a remote oil filter :wink:
tuko:
--- Quote from: NiteMare on July 11, 2011, 03:09:43 ---the 300tdi will sit on the original chassis mounts with a little creative thought and a remote oil filter :wink:
--- End quote ---
Would love to know how your doing this as I have a 300Di in my series 3 hybrid and I know for a fact that you have to make new motor mounts and relocate them. The RH side mount on the frame has to be remove to get enough clearance just to get the motor between the frame rails. Remote oil filter is not necessary for the front drive shaft clearance issues.
More info on my conversion can be seen here: http://www.tukojack.com/300di_conversion.htm
Cheers,
Todd.
Navigation
[0] Message Index
[#] Next page
Go to full version