Vehicle & Technical > Jeep
show us all
98xj:
yep the steps should be a bit more meaty and rugged looking sorry just my opinion
dxmedia:
The steps came off a couple of weeks ago - the brakets were broken (and it's funny as watching the 3yr old trying to get in an out without them) and they didn't sit straight. Looking to replace the sills with steel plate and weld tree sliders straight to them in the nearish future.
The wheels are stock ZG wheels. The tyres are 285x75r16 Maxxis buckshots (33" on a tape) Sitting on 30mm spacers.
The lift kit is a rough country 4" lift with rough country 2" spacers
Rough country +6" shocks
Llama4x4 stainless hoses
XJ front prop (sliding yoke)
Heavily cut and shunted panhards (didn't alter the brakets - modified the panhards instead. Altering the brakets limits articulation on one side of the front axle).
ARB front winch bumper from a hilux hacked to fit.
Planning on replacing the adjustable (welded up to stop rattles) radius arms for long arms at some point to make the ride a little smoother, but plenty on at the moment, like sorting the mog out :D
minimog:
this was the grand i built up
front-rear spring lift
3" skyjacker front coils
procomp dampers
homemade tube bumpers front and rear
k&n apollo closed airbox
airraid tbs
stage 2 jet chip
242 t-case swap
dxmedia:
Nice, very nice :D
minimog:
this is the new jeep to the house of mogs
not doing to much to this because ive got a yj project)
but it will have a set of my bumpers and a small lift to fit the 35" tyres/beadlocked wheels of the yj
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version