Chat & Social > The Bar - General Chat

Land Rover bump stop holder/bracket.

(1/2) > >>

mass199:
I need a couple for a project, where am i likely to get them from. I've checked paddocks etc.

The piece i need is on the chassis and has two holes in it where you bolt on your bump stop, i thought i would be able to buy a replacement and weld it on, any ideas?

landmannnn:
I couldn't find any either.  Not that difficult to make I suppose but I would still prefer to buy them made.

MuddyMike:
Come on guys, they must be the simplest of all LR parts to fabicate. If you can weld em on you can make em.

Mike

V8MoneyPit:
Or talk to Richards Chassis who should be able to supply them separately. I bought a 110 middle cross member from them once.

mass199:
Good idea, I will give Richards Chassis a ring,

Navigation

[0] Message Index

[#] Next page