Vehicle & Technical > Discovery

no clutch

<< < (4/4)

BeJay:

--- Quote from: mikiep1986 on October 25, 2010, 14:24:58 ---

 then i selected 3rd gear clutch depressed and started the engine , it moved forward a lil but then it stopped and ran ? , went to pull the clutch up lifted it about 1 cm and the clutch was fully engaged and truck moved forward , but then i depressed the clutch but it wouldnt come out of gear . if i turned the engine off it would come out of gear . . .


--- End quote ---


as said above, this comment almost certainly points to a clutch problem, (not fully disengaging) either not bled properly, or a clutch fork or release bearing problem, are you sure you're keeping the master cylinder topped up throughout the bleeding process, 'cos if you ain't and are allowing the fluid level to drop too far while bleeding out and then topping up the level you will just be putting more air in the system, sorry if this sounds like teaching my granny to suck eggs but it doesn't sound as if you're too sure what you're doing, and it's gotta be worth checking out before taking the box out again (if it's clutch fork or release bearing) hope this is of some help, cheers, Jack.

Navigation

[0] Message Index

[*] Previous page