Vehicle & Technical > Isuzu / Frontera

Isuzu 2.8 diesel turbo

(1/2) > >>

sideways1:
Does anyone know if or which engine upgrade 3.0 or 3.1 will bolt in as replacement for 2.8 diesel turbo :huh:, or which turbo will fit the same manifold? :huh:
many thanks Paul :)

ChrisV8:
Don't put a 3.00 in they are absolutely pooh and will no doubt blow up on  you !!

Think the 3.1 might fit but not sure.

Drift:
3.1 and 2.8 are the same block and ancilaries (spelling) so near enough all external parts are interchangable.

And yes the tubos are interchangable  :D

dxmedia:
Get the VICC turbo off a mk3 (3.1 trooper - 96 onwards) rather than the VIAN one off the 2.8 or the early 3.1, it's a higher output and more relaiable turbo.

You may need to rotate the inlet housing 90 degrees (ring of 6mm bolts iirc), which is very easy to do.  If your wanting more boost, find a scraped 2.8 frontera, and pull the front mounted intercooler off it. It will fit into a trooper and give a lot more cooling on the air. Also remember to change your on boost fueling to match the change in turbo / intercooler else you'll gain no benefit.

sideways1:
 :lol:just got turbo from trooper 3.1 ,will need to know how to richen mix on boost :huh: many thanks Paul

Navigation

[0] Message Index

[#] Next page