Vehicle & Technical > Discovery

camel rear bumper tow point?

(1/2) > >>

lambert:
where can i get one of the brackets that bolt onto the rear chassis crossmember, that give a vertical face to mount a pintle to?

they are the same as the ones used on camel cars and bolt onto the top and bottom of the crossmember using the same holes as the tow bar you then refit the bumper and trim out a section to reveal the holes to bolt the pintle to.

i think i saw some on a trade stand at driffield but i didn't really register what they were till now or who was selling them and i can't seem to find them on the net.

any help would be welcome, cheers.

sMUDge:
Reciever Hitches  :-k

http://www.devon4x4.com/products_a/p14770c10085/0/discovery-2-reciever-hitch.html

Or, a tank guard that also "tow's"  :clap:

http://www.devon4x4.com/products_a/p2059c10085/0/southdown-tank-guard-for-discovery-2.html

lambert:
niether of those sorry. the one i saw was a c section with the open ends bent to match the angle of the crossmember with the flat side drilled to take the bolts for a pintle.

sMUDge:
No idea then mate  :-k   

Any photo's  :huh:

weeone:
Aren't the bolts the standard M16 (is that the right size?) used on a standard 50mm ball?

Any normal drop-plate should do.
(Failing that, get a Pin'n'Ball : http://www.towequipe.co.uk/1/1/46314-witter-type-jaw-pin-tow-ball-coupling-trailer-4-ton.html or any of the 1,234 variations)

Navigation

[0] Message Index

[#] Next page