Chat & Social > The Bar - General Chat

Mig welding question

<< < (2/4) > >>

boss:
i have a new regulator, it has PSI on it, it does also have LT/min but ive always used psi. and its normally at 20psi. you should change it slightly when using higher amps though.

brixworth-alan:
33 minutes sounds like a heck of a lot of welding if you're only doing a  few seconds at a time.

dxmedia:
Not talking those cheap little disosable canisters from hellfrauds are you?  A pub co2 bottle is normally only £15

topless matt:
used pub co2 but cant stand the stuff.
I now pay BOC for argoshield, SO much better.
Easier weld, less spatter and ive found it requires less amperage to get the desired penetration  ;)

dxmedia:

--- Quote from: topless matt on June 09, 2010, 12:45:08 ---used pub co2 but cant stand the stuff.
I now pay BOC for argoshield, SO much better.
Easier weld, less spatter and ive found it requires less amperage to get the desired penetration  ;)

--- End quote ---

Get a mag welder then - designed to run on co2 :P

Navigation

[0] Message Index

[#] Next page

[*] Previous page