Pages: [1]   Go Down

AuthorTopic: transfer box output shaft  (Read 754 times)

0 Members and 1 Guest are viewing this topic.

Offline andygod

  • Regional Rep
  • *
  • Posts: 785
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Birmingham and surrounding areas regional Rep
  • Referrals: 0
transfer box output shaft
« on: April 06, 2010, 10:16:23 »
Is it possible to change the bearing & oil seal on the front output shaft without removing the transfer box from the vehicle.

Andy
Logged
Yo ho ho and a bottle of rum and jolly bad eggs are we

Offline Saffy

  • Posts: 3127
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
    • The Bell Inn, Imber.
  • Referrals: 0
Re: transfer box output shaft
« Reply #1 on: April 06, 2010, 17:41:27 »
you can remove the whole front output housing with tranny in situ.
Logged
.swonk eno oN .esoht dna eseht ,siht dna taht ,wollof ot selur emos teg eW

Offline andygod

  • Regional Rep
  • *
  • Posts: 785
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Birmingham and surrounding areas regional Rep
  • Referrals: 0
Re: transfer box output shaft
« Reply #2 on: April 06, 2010, 19:21:55 »
Do I have to remove the big round cover at the back of the box and take the bearing & shaft out that way? where are the transfer box identification numbers?

Many thanks

Andy
Logged
Yo ho ho and a bottle of rum and jolly bad eggs are we
Pages: [1]   Go Up
 





SimplePortal 2.3.5 © 2008-2012, SimplePortal