Vehicle & Technical > Defender

Defender Wheel Bearing

(1/4) > >>

Def90:
Just got the 110 through the MOT. Recieved an advisory that the near side wheel bearing was showing signs of wear - Not being familiar with replacing a whhel bear, is there a link that anyone knows of, for the process (with Pictures) to replace a wheel bearing (or tighten it)?

Defender is a TD5, registered in 2000

Cheers

Artwigwa:
This link may be of help,  :tappity:

http://forums.lr4x4.com/index.php?showtopic=10286&st=0&p=107902&hl=wheel&fromsearch=1&#entry107902

age:
.... and do it fairly swiftish - mine welded itself to the stub axle with no noise/warning at all.  Angle grinder job..... ! A

Def90:
Thanks Guys,

Will have to get the bits and have a crack at it - The little I have tried to research this, I'm surprised that the various LR part suppliers don't sell "kits" to do the wheel/Hub bearing, it seem you have to select the individual components to do the job.

Cheers

burgerman:
 A "decent" supplier should know what to sell you if tell um what ya up to,   I have changes all mine on our TD5 90 for the earlier type set up, That way i can strip and/adjust um a lot easier, Bit of a mucky job but should be pain free 8-[  :lol:

Navigation

[0] Message Index

[#] Next page