Vehicle & Technical > Series Land Rovers

One piece ser 3 screen

<< < (2/2)

stevethedent:
Anybody out there successfully fitted a defender screen to a series? :rolleyes:

Artwigwa:

--- Quote from: stevethedent on March 20, 2010, 15:59:33 ---I got fed up of the restricted view from my ser 3 and now I have got the parabolic suspension thought I would set about finding a soloution, so here goes:
To avoid the risk of a disaster I bought a used screen of ebay for a fiver and removed the glass by undoing the small screws that keep the screen retaining angle iron in place. Then running a staley knife around the edges of the glass and then removing the glass. Using an angle grinder carefully cut out the centre divide level with the frame. I then cleaned and sanded the whole fame and painted with silver hammerite. I went to a glazing company and got them to cut me a new single piece of laminated glass 6.4 mm thick 1420mm x 1355mm x 360mm asked them to etch on laminated glass kite mark to avoid any MOT test problems. You will need some 10 mm double sided tape for the inside edges of the screen and a tube of silicone with a suitable gun. stick the tape to the edges of the inside of the screen then run a beed of silicone around the window frame about the thickness of a biro. place the glass in the frame and carefully apply a little pressure to bed the glass and then replace the angle iron retainers. turn the frame over and wipe any excess silicone off the screen with a rag soaked in paint thinners. job done. It makes a big difference with little effort. Good luck with it. If you need any more info give me a shout on here.  :clap:


--- End quote ---

 :dance: Please, let's see some pics!!  :lol:

stevethedent:
OK I will try and post some pictures. I Know this looks like a defender but trust me it is a 1984 series 3

Navigation

[0] Message Index

[*] Previous page