Vehicle & Technical > Discovery

Tow bar

<< < (2/3) > >>

wonderboy:
They do look solid.  How do they fix on, as where the tie down brackets fix, whats left of them is rusted in.

KingWolf:
They fix on to the same locating points as the standard towbar would. So thats the two in the rear cross member and the two on the chassis. As you said, where the standard lashing points are, it's a bit fiddly as you only have a small slot in the tank guard to be able to get the nut up through the hole. If your standard bolts are seized in place (mine were) then you'll have to try and heat them up and hope for the best. Thankfully mine came out.

Mark.

wonderboy:
Looks like ill be getting the blow torch out then!

ukmudmaster:
A quick and cheap remedy for the "plough" is cut it down and redrill towbar holes as high as possible, you can gain 6' to 8" of clearance .
Dave

LiftedDisco:
PM sent... one on the Bay right now...

Navigation

[0] Message Index

[#] Next page

[*] Previous page