Vehicle & Technical > Discovery

ATF temperature warning light

<< < (2/3) > >>

jkseries:
Fantastic advice from the site as always.

Located, cleaned and refitted and voila  ....  no light.

Just need to make a decent seal around it and the problem's gone.

J

BigA:

--- Quote from: jkseries on November 19, 2009, 11:33:52 ---Fantastic advice from the site as always.

Located, cleaned and refitted and voila  ....  no light.

Just need to make a decent seal around it and the problem's gone.

J

--- End quote ---

Glad you sorted it. Loads of insulating tape and a couple of cable ties

landroverkeith:
God Bless Cable Ties

jkseries:
I think it's also worth noting that on mine it was a VERY POOR connection.  With it all cleaned up and sealed all i have to do is touch the wires going into the top to make the light come on.

Further investigation is required I think.

J

BigA:
if i remember correctly  :-k the connector block that plugs in has two spaded connectors in it. is it possible to close them up a tad with some pliers to try and tighten the plug ?

Navigation

[0] Message Index

[#] Next page

[*] Previous page