Vehicle & Technical > Not Anything Listed Above....
Sportrak rear brakes
horsethief:
Doing my rear drums on a diahatsu sporti.The maual says use M10x1.25 bolts as pullers,but I've tried them and they don't fit,am using the old screwdriver method to remove the drums to clean them out.Does anyone know what size they are?
buckshot:
they should be M10 but they get worn out . had to retap mine out to M12.using the bolts as pullers is by far the easiest way of removal provided you wind them in evenly.
frosty:
drums?
how come ive got discs on the rear of my h plate?
im hoping thats not a conversion because if it is i havent got a clue what the donor vehicle was!
horsethief:
Just been searching for these bolts.The only ones that come up are brake banjo bolts.Has anyone goy an idea where to get m10x1.25 bolts in manchester?Some fourtraks had discs front and rear.
buckshot:
they are,nt anything special they are just common standard thread ironmonger bolts length is,nt to important as they only draw the drum off 70to100mm would do the job fine.
Navigation
[0] Message Index
[#] Next page
Go to full version