Vehicle & Technical > Series Land Rovers
Still won't go!
Saffy:
--- Quote from: Dave123 on October 19, 2009, 20:14:14 ---
--- Quote from: Tanglefoot on October 19, 2009, 13:10:23 ---
--- Quote from: Dave123 on October 17, 2009, 21:24:52 --- Like I said, the clutch dissapeared overnight. I parked it, went to drive the next day and nothing..
We tried to start it in gear the day it happened and it rolled forward, we also tried to start it today in gear and it rolled forward again so I'm clueless.. I'm puling my hair over it.. There's lots of reasons a clutch could do that But very few over night.. I'll order a slave cylinder and hope that fixes it, if not.. Time to take the Bell-housing off I guess :roll:
--- End quote ---
doesn't the series bell housing have an inspection plate? think it does :-k maybe you can have a looksee thru that - dunno what the hell you would see though :cheesy:
--- End quote ---
That's what I've been told! :shock: Bot god Knows where it is! :?
--- End quote ---
unbolt the transmission tunnel you should see it.
Dave123:
Cheers mate ;) I've found a very nice chap who's offered to let me use his ramps and garage space this weekend, He's also offered to tow the car out to his garage for me to work on it. So it'll get fixed no-matter what! :twisted:
I shall Update this thread with an answer hopefully in-case anyone experiences the same symptoms...
Once again, Thanks very much for your time, sometimes I'd be lost without this board and the kind and helpful people who make it what it is! :dance:
Dave123:
:D All fixed, turns out it was the Clutch siezed to the flywheel but don't understand why the pedal wasn't solid! :?
Next problem is that my speed drive is not driving, Whats the common problems here.. It's definatley the drive because I span the cable on the drill ;)
Someone said about the part the cable sits in could be rounded off? Also that the gears have been stripped on the drive and something to do with tightening the nut in the middle of the handbrake?!?!
All I know is it's gonna be a PITA because the main shaft is in the way of one of the screws :evil: So I'll have to pull it right apart!
Navigation
[0] Message Index
[*] Previous page
Go to full version