AuthorTopic: vitara losing water  (Read 1112 times)

0 Members and 1 Guest are viewing this topic.

Offline mudbitz

  • Posts: 15
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
vitara losing water
« on: October 02, 2009, 19:24:46 »
got a 8v swb vitara 93 model
loses a bit of water
oil is black no mayo
starts first time
performance ok
any idea why it will lose half a litre on occasions other times not

Offline generation-x

  • Moderator
  • ***
  • Posts: 2057
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Mega-Fronty
    • church stretton
  • Referrals: 0
Re: vitara losing water
« Reply #1 on: October 02, 2009, 19:57:08 »
tbh
sounds like head gasket failure and its losing threw the exhaust system
if pennies allow buy one of these and give it a test

http://cgi.ebay.co.uk/ENGINE-CYLINDER-HEAD-COMBUSTION-LEAK-BLOCK-TESTER_W0QQitemZ160366280310QQcmdZViewItemQQptZUK_Diagnostic_Tools_Equipment?hash=item2556933e76&_trksid=p3286.c0.m14


Simon

Offline mudbitz

  • Posts: 15
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +0/-0
  • Referrals: 0
Re: vitara losing water
« Reply #2 on: October 03, 2009, 07:57:05 »
thanks
are you still fabricating su hif 44 inlets for 8v vit
if so pm me
gdb123@blueyonder.co.uk

Offline generation-x

  • Moderator
  • ***
  • Posts: 2057
  • Attack: 100
    Defense: 100
    Attack Member
  • Karma: +1/-0
  • Mega-Fronty
    • church stretton
  • Referrals: 0
Re: vitara losing water
« Reply #3 on: October 03, 2009, 12:21:11 »
thanks
are you still fabricating su hif 44 inlets for 8v vit
if so pm me
gdb123@blueyonder.co.uk

hi m8
sorry no i no longer make these up as were no money in them
sj-uk(parasource) did take over my pattern but again i think he has stopped making them due to costings

imho a modifyed inlet manifold is the way to go a member on www.shrsophire-suzuki.co.uk now makes these and
id reconmend his work 100%
his SS id is rockwatt and he re makes the manifold to accept an su carb so no messing about welding bends and plates together
hope this helps

simon

 






SimplePortal 2.3.5 © 2008-2012, SimplePortal