Vehicle & Technical > Range Rover

tank guard

(1/4) > >>

JIMBOBLY:
ive bought a fuel tank guard for the rangie,one with the detatchable tow hitch,i can see how the guard bolts on where the holes are for the original tow bar bracket that go through the cross member,and the bolt holes where i have got the jate rings at the mo,but there are 2 bolt holes right at the front of the guard,that dont line up with any holes in the chassis rails or anything,is there a missing bracket,or have i been sold the wrong guard,its s/hand,it said it was for a classic,any help will be much appreciated,jim :-k

hairyasswelder:
Fitting instructions are on Southdown website  ;)

http://www.southdown4x4.co.uk/Fitting/FitDiscoDTP.jpg

Hope this helps

Steve

Bowie:
You don't need the most forward bolt holes unless you get involved with silly silly 'extreme' recoveries, and as your truck isn't orange you'll be fine ;)

JIMBOBLY:
 :Dwell thankyou to the two thar replied,that has solved my problem,nice one cheers,wont forget it,jim :D

Range Rover Blues:
If you do use the front set of bolt holes you should reinforce the chassis to stop it collapsing when you tighten them.  Under normal use the front edge of the chassis fits under a chassis crossmemeber to transfer load into the chassis.

Navigation

[0] Message Index

[#] Next page