Vehicle & Technical > Defender

bulkgead outriggers

(1/1)

CHIPFAT:
I have been thinking of building a 100" landrover trayback on a disco chassis
Ive got a 110 pickup with a rusted out chassis already
Now here's the question, which bulkhead outriggers should i use series or 90/110s
90/110s are easy to fit but expensive (£45 each)
Series can allow a slight body lift when fitted higher up the chassis rails and are cheap (£15 each)
I was swaying towards the series outriggers mainly due to cost
If anybody fitted the series outriggers on a hybrid, how easy were they to fit, or are they just a P,I,T,A
Or should i just bite the bullet and get 90/110s

bogie:
Go for series,u get the lift and if you muck up you get 3 attempts for the price of one!

CHIPFAT:

--- Quote from: bogie on September 06, 2009, 21:00:09 ---Go for series,u get the lift and if you muck up you get 3 attempts for the price of one!

--- End quote ---
I like your plain of thought with that suggestion! :clap: :clap:

bogie:
Makes  sense! How about making some of those chip fat badges,there good!!!!!!!!!!!!!!!!!!!!

CHIPFAT:

--- Quote from: bogie on September 08, 2009, 20:50:23 ---How about making some of those chip fat badges,there good!!!!!!!!!!!!!!!!!!!!

--- End quote ---
if only you could realise how many hours this one took! :-$ (i know wasted life etc :))
i know there must be a faster way of doing them, but i just dont know how!

Navigation

[0] Message Index