Vehicle & Technical > Range Rover

which wire does what

<< < (2/2)

clbarclay:
What vintage RRC is this. Looking at 1987 wiring diagram

White/red wire is to the starter motor solenoid
White is to the ignition load relay (items like warning lamps are fed via a relay rather than directly from the ignition switch) and also coil + EFI
Brown is the direct battery positive feed
White/orange is the ignition axillary (radio temp supply)


We put a push start on the G wagon at home, but that was due to a fault with the origional wiring and was simply a push swtich that only operated the starter solenoid via a fresh wires from the battery.

For an off road only vehicle you could probably just wire the brown to a kill switch and every thing else to the the other side, with the push switch inline with the white/red.

muddymud:
that sounds about rite to me i will give it a go i have loads of switches and buttons to use. i was going to do it today but went out on the mountain bike. hear is the truck, i haven't done anything to it YET! but i have some plans for it when i get my workshop doors sorted.

spec:
3.5 carb V8 (going to be a 200tdi on a zf 4 speed if i get my way)
3" pro comp lift
4 point harnesses
QT diff guard on the front and a cheep one on the back
5X 7.5x16" dumpers
roll cage 





cost me £320 so i don't think its too bad. what do you lot think?

Cheers,
Nick

300TDi Disco:
Time to get your hands dirty and start doing the long list of jobs you need to do. Is there any landrover out there that doesn't have a list of jobs to do. I havent seen the end of my list for a long time.

muddymud:
i want to keep it farly simple for this one. i am going to try and spend as little as possible on it, when i have the list sorted i will post it up.

Navigation

[0] Message Index

[*] Previous page